Airpro Snowbike Bottoming Kit

New

Please Refer to the fitment guide below

Is your snowbike fork bottoming? Stop it with a snowbike front fork bottoming kit. This snowbike accessory is made in the USA and features an infinite range of quick and easy air pressure adjustment in the outer chamber of the front fork, saving the rider upwards of $500 compared to a revalve and new springs. Standard snow bike setups weigh 65 to 85 pounds more than a stock dirt bike (BEFORE you add racks, packed snow, spare gas, etc), which leads to violent bottoming and bent lower fork tubes. AirPro prevents bent fork tubes and snowbike bottoming by allowing you to add 10-15 pounds to your outer chamber.

What happens when the snow melts? The kit swaps back in less than 10 minutes when the bike is ready to ride dirt trails and motocross tracks (unlike expensive snowbike spring and valve jobs). Did we mention there is a no questions asked, lifetime warranty?

More details

In Stock

$168.99

Add to wishlist

More info

WARRANTY-PHONE 208-283-8419OR EMAIL airprofork@gmail.com

Q: Why do I need an AIRPRO for the front suspension on my snow bike?
A: Snow bikes are approximately 65 to 85 pounds heavier than the stock motorcycle (without considering the weight of any snow, auxillary fuel tanks, racks, etc on the bike)  
With the standard fork setup, severe bottoming will occur if ridden even semi-aggressively. Very aggressive ridingwill bend the lower fork tubes and lead to major expenses .
Most snow bikes kits utilize a thick aluminum plate/adapter to attach the front ski to the forks and these adapters reducefork travel by approx .75 to 1.5 inches.

Q: Can I just pay to have my forks revalved, resprung, and use heavier oil and increase the oil level?  
A:  Yes, but those modifications can cost upwards of $600 to $800 vs. the $169 Airpro kit. Also, the Airpro allows a rider to adjust the bottoming resistance while on the trail, within seconds.

If an owner still chooses to revalve and respring the fork, when it's time to convert the snowbike back into a regular dirt bike, the front forks will need to be resprung, revalved, and oil level adjusted again to obtain good handling characteristics when ridden off road or motocross. With the Airpro, the kit stays installed year around and the owner simply bleeds the air from the schrader valve or you can contact Airpro for their fully automatic fork bleeder system.      

Q: Will the AIRPRO lead to a rougher ride?
A: The Airpro allows the rider to adjust air pressure for any condition. If the fork ride feels too firm, decrease pressure to 5 psi.  If the fork bottoms out on big impacts,  increase the psi to 10 to 15. You still retain the stock compression and rebound adjustment clickers with an Airpro.

Q: What models will the AIRPRO fit?
A: We offer Airpros for KTM, Yamaha, Kawasaki, Suzuki, Honda, Husqvarna, and Husaberg and Sherco. 

Q:  Will the added air pressure cause fork seal problems or internal damage to the fork?

A: Not at all. We performed extensive tests over a two year period at various psi levels and up to 60 psi with absolutely no issues. We saw no fork seal failures and the internals of the forks looked new due to the fact the severe bottoming was eliminated.

part number 1.JPG

part number 2.JPG

Reviews

No customer reviews for the moment.

Write a review

Airpro Snowbike Bottoming Kit

Airpro Snowbike Bottoming Kit

Please Refer to the fitment guide below

Is your snowbike fork bottoming? Stop it with a snowbike front fork bottoming kit. This snowbike accessory is made in the USA and features an infinite range of quick and easy air pressure adjustment in the outer chamber of the front fork, saving the rider upwards of $500 compared to a revalve and new springs. Standard snow bike setups weigh 65 to 85 pounds more than a stock dirt bike (BEFORE you add racks, packed snow, spare gas, etc), which leads to violent bottoming and bent lower fork tubes. AirPro prevents bent fork tubes and snowbike bottoming by allowing you to add 10-15 pounds to your outer chamber.

What happens when the snow melts? The kit swaps back in less than 10 minutes when the bike is ready to ride dirt trails and motocross tracks (unlike expensive snowbike spring and valve jobs). Did we mention there is a no questions asked, lifetime warranty?

4 other products in the same category:

Secure SSL Certificate